How to pair the Tow-Pro Link main unit to the remote

Pairing to the main unit 

The Tow-Pro Main Unit and Remote are supplied factory-paired when purchased as a complete system, so Manual Pairing is not needed. 

If the Main Unit or Remote were purchased separately or as a replacement, they must be paired before use. 

Before you begin pairing process, make sure:

✓ the trailer is attached; 

✓ the vehicle is completely stationary and the hand brake is applied; 

✓ accessories/ignition is turned on (i.e., the Main Unit and Remote have power); 

✓ the Remote starts, at power-on, with no LED indication; 

✓ the Main Unit is not connected to another Remote. 

1. Pump the vehicle brakes 3 times to enter pairing mode on the Main Unit. When pairing mode is active, the trailer's brake lights will flash slowly. 

   NOTE: The Main Unit will exit pairing mode if no device is found within 10 minutes, or if the vehicle moves. If this happens, you need to unplug the trailer plug from the vehicle and then reconnect it before entering pairing mode again.

2. On the Remote, press-and-hold the SwayStop Button and Minus Button at the same time until the LEDs begin to flash blue. Release the buttons.
3. The Remote LED will continue to flash blue as it attempts to connect to nearby devices.
4. When the Main Unit establishes communication with the Remote, the LED will begin to flash blue faster.
5. To confirm pairing, immediately press-and-hold the vehicle brakes, then press-and-release the SwayStop Button once. When successfully paired, the LEDs will remain solid blue (if in Everyday/Proportional mode) or solid green (if in Manual Off‑road/User Controlled mode). Release the vehicle brakes.
6. If this process fails at any stage the LEDs will turn off. Return to step one and try again.